Ardu-chute. 433mhz wireless ardu parachute

$30-250 USD

Færdiggjort

Slået op

cirka 11 år siden

$30-250 USD

Betales ved levering

I want to make a R/C parachute system for my rc plane. Currently I have an arduino uno which has a push button on input A0 and this board sends out a serial value over a 433mhz tx from digital pin 2 I am recieving ok as watching the nano on the serial monitor it sees the change from 0 to 1023 when I press and hold the button down for a little bit I am very new to Arduino and have reached my current limits. So I seek your services and skills for what I would like to achieve below. UNO- is transmitter end. I want sketch which will only transmit a character command "popchute" once a push button has been pressed, I want a LED output to go LOW when the button is pressed. NANO- receiver end I want this to have 2 inputs as well as the recieved character command. input 1- push switch once pressed arms parachute system and will allow output IF input 2- is released (unpushed) (this happens once drone takes off/switch not making contact with the ground) If command is received and inputs 1 has been armed and input 2 has gone low I want 2 output pins made high. I hope this helps you see my vision?

Arduino

Electronics

Microcontroller

Projekt-ID: 4511994

Om projektet

3 forslag

Projekt på afstand

Aktiv 11 år siden

Leder du efter muligheder for at tjene penge?

Emailadresse

Fordele ved budafgivning på Freelancer

Fastsæt dit budget og din tidsramme

Bliv betalt for dit arbejde

Oprids dit forslag

Det er gratis at skrive sig op og byde på jobs

Tildel til:

@cbayanwala

I am currently working on my quadrotor, and have a good idea about these systems. Please check your pm for more details.

$55 USD på 15 dage

0,0

(0 anmeldelser)

0,0

3 freelancere byder i gennemsnit $90 USD på dette job

@betaenergy

Dear Sir, We are Reserach and Development company whose working area are : -Digital Motor Control -Analog Design -Electronic Design -Power Electronics -PCB design -Embedded system -Matlab -Simulation of hardware For each concept descriptions are as follows: Digital Motor Control: -3-phase induction motor vector control drive -Flux estimation algoritm generation -DSP(TMS320) implementation on motor drive -Low speed application -Torque and speed loop generation -Control algoritms Analog design -Low power distribution -Noissless special opamp based analog circuits -Analog filters -Orcad simulation of several circuits Electronic Design -RF transmitter and receiver -Bluetooh reader and transmitter -Magnetic reader Power Electronics -Implementation motor drive -AC/DC converter -DC-DC converter -Battery charger -Solar inverter -Renewable Energy simulations -Uninterruptle power supplies PCB design -Schematic design by Altium -PCB design by Altium -Power board design -SMPS board design Embedded system -PIC18,PIC24,PIC30 and dsPIC applications -Ardino -MSP430 -Atmel -DSP(Texas Instruments) -Renesas Matlab -Power Electronics simulation -Motor drive -Wind Energy -Solar Energy -Control applications Simulation of Hardware -Orcad Simulation(TI,National, Linear Tech, Maxim libraries) -LTI -National -Matlab Very important Note: References attached. Please look excel file to see projects which we made until now! Metin

$210 USD på 3 dage