Writing a MSP430 microcontroller software in C, which uses DMA to write data to a LCD (132x64 pixels) with a SPI interface

The requirement is very simple and straight forward: I need a software/firmware written in C for MSP430F533x microcontroller family, which uses DMA to transfer data to a LCD (pixels = 132x64 ) with a SPI interface. I have some graphics stored in microcontroller memory in an array (1056 bytes) and that array (i.e. 1056 bytes) should be written to the LCD using SPI interface using DMA. The software/firmware should notify the end of DMA transfer using an interrupt or setting a software flag. Please find below the requirements of the software: Microcontroller : MSP430F533x family (MSP430F5333, MSP430F5335, MSP430F5336, MSP430F5338) C compiler / IDE : TI CCS V5.5 or above LCD info : 132x64 LCD with an SPI interface. LCD connections to the microcontroller will be provided to the winning bidder as a PDF file. LCD controller UC1701x. LCD init. codes provided if required. Expected outcome: The CCS V 5.x/6.x project file which can be built without errors on an CCS V5.x/6.x required with all the source files and libraries. The source file should containC functions to do following things* : (a) DMA init, (b) Set DMA address and channel (c) start DMA data transfer enable *one of those functions should accept the array (of 1056 bytes (unsigned char)) as an input You may use libraries from internet, example code from TI or anywhere (I don't care from where you get it), but all the source of the libraries required. A file with main(), which writes the byte array approximately once a second, and goes to LPM4, and wakes up after one sec. in an infinite loop. Note : you can use code from anywhere, I don't mind even if you modify the example codes given in TI website. All I need is a working software/firmware with above requirements. An experienced MSP430 programmer should be able to complete this one within hours time. Please do not hesitate to ask if anything not clear.