Arduino controlled buck converter Step-Down Power Supply Module LM2596S
$30-250 USD
Færdiggjort
Slået op cirka 6 år siden
$30-250 USD
Betales ved levering
i need to modify the Buck Converter Adjustable Step-Down Power Supply Module LM2596S as you can see it in the below link
I need it connected with arduino stm32f103 blue pill, it shall have an encoder with a button to change the voltage also connected to ili9341 tft lcd to show the readings and a menu using the encoder to setup and save the settings withing the stm32f103 using stm32duino . also i need you to write arduino library to control it via rs-232, i2c and spi.
[login to view URL]
[login to view URL]
Acceptable terms of payment is single milestone when job is done and verified.
have a good experience with arduino specially in robotics field more than 4 years
you can check my Portfolio and you will find some of my Robotics and arduino based projects.
$88 USD på 3 dage
5,0 (8 anmeldelser)
3,1
3,1
13 freelancere byder i gennemsnit $143 USD på dette job
Depend on your type of load i dont recomended LM2596S
buck converter is a simple circuit but to control it u need high pwm
and some interfacing circuit.
Hi,
I would love to work on this LM2596 control project and will design and provide you with schematic and firmware code to test and then you can release milestone upon verification at your end and then I will send you source code.
Please contact.
regards,
Ali