Make into a vector drawing

Status: Closed
Præmier: $30
Modtagne indlæg: 11
Vinder: nasta199630

Winner

Konkurrence Instruktioner

I need this stencil made into a vector drawing to be used for laser cut out software.

Winner must provide the drawing:
in vector form with the dark areas to be black vectors.
Size: 22 cm
A black rectangle border 1.5 cm around from the image
File must be illustrator.

To be awarded, you must provide the illustrator file plus the image as a JPEG and PDF.

I have scanned the image but it didn't come out clear. I took a photo so you can see it better. The image of the wood on it's side is so you that you understand that the black part must be cut out so the lines CAN NOT join

Anbefalede færdigheder

Winner

Opret en konkurrence som denne

Arbejdsgiverfeedback

“great work. follows directions and made any changes I needed”

annaskoubourdis, Australia.

Bedste indlæg fra denne konkurrence

nasta199630 Ukraine

0
nagmulislam9822 Bangladesh

0
nagmulislam9822 Bangladesh

0
nasta199630 Ukraine

0
Sico66 Venezuela

0
nhicko07 Philippines

0
vmttnt Vietnam

0
nasta199630 Ukraine

0
markovicnatasha Serbia

0
ROMANBD7 Bangladesh

0
ROMANBD7 Bangladesh

0

Se flere indlæg

Offentlig Præciserings Opslagstavle

nasta199630
- 4 år siden
Please check #54 #55 Thank you!!!
- 4 år siden
Konkurrenceafholder
- 4 år siden
Border is to be 2mm thick ONLY. Border is to be 1.5 cm from the sides of the image. If you make the eyes cross eyed, you will be rejected without feedback. If you alter the picture from the original, you will be rejected without feedback.
- 4 år siden
Vis 1 besked mere
1. nasta199630
  - 4 år siden
  Please check #47 #48 Thank you!!!
  - 4 år siden
2. Konkurrenceafholder
  - 4 år siden
  Nhick...read the comments below. the border needs to be 1.5 cm from the image
  - 4 år siden
FEROZuddin05
- 4 år siden
Sir please check #49. I can customize anything that like you want.
- 4 år siden
Konkurrenceafholder
- 4 år siden
The reason noone is being awarded is because the border is too wide and long and too thick. follow the instructions given EXACTLY.
- 4 år siden
nagmulislam9822
- 4 år siden
sir,
please check #27 #28
thank you
- 4 år siden
Konkurrenceafholder
- 4 år siden
Please note. this will be cut out of wood. The lines around the face need to be the same thickness. Not drawn to a point. Also there are wide spaces on the chin line but everyone is making those spaces smaller
- 4 år siden
1. nasta199630
  - 4 år siden
  Please check entry #19 #20 Thank you
  - 4 år siden
Konkurrenceafholder
- 4 år siden
border should be 2mm thick
- 4 år siden
manjiribhave
- 4 år siden
Hello, I do lot of hand sketches and digital drawing as well. My expertise is in Adobe Illustrator . Working on your project. Please wait for my entry
- 4 år siden