Filtrér

Mine seneste søgninger
Filtrer ved:
Budget
til
til
til
Slags
Evner
Sprog
    Job-status
    8 labview fpga jobs fundet, i prisklassen EUR

    ...i need a simple program that can calculate time (using hight precision timer, better in micro seconds) between 2 external triggers. Here can be useed FPGA Hardware for example (personaly i prefere FPGA for such task) Frequency range from 0,1 to 100 Hz to be tested. i have programm already done (see attachement), on my laptop i got only value for frequency

    €32 (Avg Bid)
    €32 Gns Bud
    4 bud

    The project goal is the implementation of a Verilog module to interface a high-speed ADC (250MSps) using DDR. The IO/delay shall be dynamically adjusted after reset thru a test pattern match using a test mode of the ADC. As part of the project a simulation test bench needs to be set-up to verify proper function of the interface.

    €1186 (Avg Bid)
    €1186 Gns Bud
    13 bud

    I have a de1-soc fpga board ([log ind for at se URL]) for the detail. currently i have difficulty id generating code for image processing for my image. I have a completed matlab code that include the image and filtering kernel. I need the code to run into my fpga board.

    €31 (Avg Bid)
    €31 Gns Bud
    1 bud

    We're looking for someone with experience is sending data from an FPGA to a PC via a FT601 chip (made by FTDI) and saving the data to a binary file on the PC side.

    €35 / hr (Avg Bid)
    €35 / hr Gns Bud
    8 bud

    an expert on FPGA and Verilog should bid only...

    €141 (Avg Bid)
    €141 Gns Bud
    12 bud

    FPGA based VHDL code of control system device, the design should be handwritten, not generating code. The FPGA design must have the std logic data type of the inputs and the outputs and S-Fixed numbers of the entire control design

    €102 (Avg Bid)
    €102 Gns Bud
    6 bud

    FPGA based VHDL code of control system device, the design should be handwritten, not generating code. The FPGA design must have the std logic data type of the inputs and the outputs and S-Fixed numbers of the entire control design.

    €146 (Avg Bid)
    €146 Gns Bud
    7 bud

    ...ECG to the heart into a breadboard which is then connected to a DAQ in the computer. We need a VI that will show the pulse on a waveform chart, the BPM, and we need to tell LabVIEW the normal parameter ranges (with 10% accuracy) of the heartbeat. We also need a Boolean light that would indicate if the heartbeat is normal (in the ranges) or abnormal (outside

    €154 (Avg Bid)
    €154 Gns Bud
    11 bud