TOTAL 10 YEARS AND 5 MONTHS OF EXPERINCE IN EMBEDDED SYSTEMS DESIGN AND DEVELOPMENT Detailed experience summary o 5+ Years of experience into Embedded Linux and Device Drivers. o 3+ years of Embedded Firmware design and development (Non-OS). o 2 Years of Experience in Hardware Design and Development. o Extensive experience with hardware and software designs for real-time and Embedded Linux systems, software hardware engineering, design and development, project management, technical writing, research, training, team development, problem solving, planning, and successful execution of product development and support activities, providing design solutions to key customers, handled critical technical issues, product certification and product enhancements o Embedded Linux Device driver experience: TFT LCD, USB, SDRAM, NAND and NOR Flash Drivers, Bootloader, Board Support Packages, Board Bring up Activities, TFTP Boot etc. o Work experience in 8, 16 and 32 Bit microcontrollers. o Work experience in serial communication protocols and device drivers for CAN, USB2.0, SPI, IIC, TWI, USI, USART, PS/2, RS-232 and RS-485. o Work experience on USB DFU bootloader for AVR chips. o Work experience on CSR8670 based Bluetooth module hardware design o Work Experience on device drivers for peripherals like ADC, DAC, TFT LCD, Dot Matrix LCD, SDRAM, NAND Flash, NOR Flash, EEPROM and Bootloader- (Non -OS based).. o Work experience in CANTrcv firmware as per AUTOSAR 2.1 and 3.0. o Work experience on various architectures: ARM, SAM, i.MX21s, AVR, PIC, RISC and CISC, ARM, 8051, o Work experience in Linux, Board Support Packages, Bootloader UBoot etc firmware development o Work experience in JTAG, BDM, ISP and In-Circuit Emulator (ICE). o Work Experience Linux, Linux Kernel, GDB debugger, RTOS Vx-Works and tools - Vx simulator, Cross wind Debugger. o Work experience on MATLAB. o Design experience in hardware as per IEC Medical Safety and electrical standards. o Handled multiple projects in parallel and experience on project estimation, project planning both in cost and time. * Work experience on MATLAB, Simulink etc