Electric Vehicle Charger Communications Board Light Version
This is the light version of the Electric Vehicle Charger Communications Board that is at its fourth version. It has a P1 Main Board Controller, that contains both a Wi-Fi chip and a STM32 32-bit ARM Cortex-M3 microcontroller, sampling current capability using a Current Transformer, a Watch Dog, Real Time Clock, FRAM memory and some programming and utility headers. My responsibilities were to design the entire system circuitry, to create the schematics, schematic library, footprint library and layout the board.
Hi. I am an electronic engineer, specialist in microcontrollers and embedded software programming; schematics capture and PCB routing. I have been working in several companies, with 7+ years of professional experience in the embedded software field, and I have developed embedded software for a wide range of products. Following up I list the main technologies I've usually worked. - Electrical scheme design and Firmware programming, such as: analog and digital circuits, wireless circuits(BLE, Wi-Fi, RFID, etc), circuits based on microcontrollers or microprocessors. - Ultra-High frequency circuit analysis and design : UHF/HF analog circuit design, High frequency digital circuit design such as DDR3, eMMC, Flash memory, 1Gbps Ethernet circuit design - Embedded software : I have much experience in developing for AVR, PIC, STM32, ARM, Arduino, Raspberry Pi, Waspmote and etc. You could realize your idea at a time , we can guarantee high quality of results. Regards.