Annulleret

Google sketchup presentation

I want a short presentation of the model in google sketchup. Basically I want the presentation to orbit the model, zoom into key locations and display a label at each location. The presentation should pause for 3s at each label and carry on. The presentation must loop and keep repeating.

Please see the attached sketchup model and the labels I need to you add.

The title of the presentation is "Sorting machine".

The entire presentation

The labels of the key location are as follows:

1) Card stack holder/dispenser.

2) Roller to eject cards.

3) Roller motor

4)Multiple card barrier.

5) Ramps to hold the card.

6) Illuminating LEDS for orientation detection.

7) Photoresistor for orientation detection.

8) 12V Solenoids to pull out the ramp

9) Rotating bin

10) Rotating Bin motor

11) Break signal system for bin position detection.

12)Break signal generator.

13) LCD display

14) Button 0

15) Button 1

16) Potentiometer for sensor calibration.

17)Emergency stop

18)On/Off toggle switch.

19)power supply socket.

I need this within 1 day of bid acceptance. It should not take more than 1.5 hours for a sketchup pro

Evner: 3D Animation, 3D Modellering, Visuel Kunst

Se mere: system sensor, supply pro, sketchup 8 pro, sketchup 8, model for sketchup, google sketchup 6, stop animation, sketchup, roller, presentation card, POWER SUPPLY, orbit, google sketchup, calibration, animation pro, animation presentation, power presentation, Google sketchup Model, model google, google sketchup animation

Om arbejdsgiveren:
( 29 bedømmelser ) TORONTO, Canada

Projekt ID: #3316992