I need a small object designed for a 3D printer (for whatever format the printer requires).
Dimensions will be something like the following -
-Approx 4 to 7mm in diameter in two halves
-Will support an internal 41mm tube of approx [url removed, login to view] diameter
-Where it supports the tube on either side it should not be smaller than [url removed, login to view] then open up to the end diameter below
-Overall the length will 60mm
-It will be in two halves initially with clips that lock it together
-It will form a 3.1 mm hole on each end but be designed to clamp down with threads
-A separate end (essentially a nut) will thread on either end and clamp it down to [url removed, login to view] when tightened.
-The threaded part must be no more than 5mm long on each side
Project payment on full accepted completion only! <-- Put these words in your bid or it will not be accepted!
7 freelancers are bidding on average $44 for this job
Hi my name is Abraham, I am an architect and a designer specialized in 3d design, modeling and rendering. I would like to work in your project. Best regards.