I am a registered Professional Engineer in the US and have a proposal pending which requires the structural analysis for some aluminum extrusions. If I am award the contract then I will need the the following completed within 3 days of the notiice to proceed, which is likely to be within the next week.
I have attached ACAD drawings for two extrusions and I need it to be modeled in 3-D and the following structural analysis completed all units shall be in both SI and US:
Maximum Allowable Bending Moment
Moment of Inertia
The material will be Aluminum 6061-T6
I will also need to determine the pullout capacity of the channel at the top of the extrusion, assuming a boat cleat is attached and horizontally loaded at 75mm from the top of the of the extrusion.
I expect to have a typed report with the details of all structural calculations and any structural modeling output files. This should be a fairly easy project for the right person. I expect that after this project there will be an additional 80 hours of detailed structural analysis of associated with a floating docks and truss systems.
We are a wide-ranging team with 2 highly experienced structural engineers (check our CV).We’ll be glad of solve this and any other task in programming and engineering you might have.