Lukket

Tekla Automation - 5x5mm snipes reqd

5 freelancere byder i gennemsnit $166 på dette job

seemasit

Hello, I just saw your project so I can do this type of project very quickly because I have done this type of project so come on the chat for further discussion Thanks

$155 AUD in 3 dage
(20 bedømmelser)
5.2
CyB34r

Hello! I am not a Tekla macro expert yet, so I'll be honest, at the moment I don't know exactly how to do your requirement. I just started a job here in Mexico where I have been making some automated reports in Tek Flere

$155 AUD in 7 dage
(1 bedømmelse)
1.1
KareemEssam94

Hello, I can help you with this project, I can make this macro but i will need more information wich we can discuss over chat

$133 AUD in 3 dage
(0 bedømmelser)
0.0
jeemonvg

Dear sir, I would like to do this job,Have more than five years of experience in structural design and detailing. Highly experienced in site management, structural designing and detailing. Am using STAAD PRO and C Flere

$250 AUD in 3 dage
(0 bedømmelser)
0.0
S2GTP

making 5x5 snipe on any plate is possible thru Custom Component. I already made for stiffener edges. the same component can use any where . component made in TS V19, so you can use TS V19 and above

$138 AUD på 1 dag
(0 bedømmelser)
0.0