I would like to have a fork of Slic3r that enables me to print external perimeters with my set
height (set in the GUI, 0.1mm) and infill also with a custom height (set in the GUI, 0.3 mm).
This will be a fork on Github.
The GUI of Slic3r is in Perl and the core code is in C++ 11.
I have a little knowledge of Perl and C++ and focus more on the hardware.
Also is there a way to improve the tool travel algorithm because at the moment it
wastes a lot of time just repositioning the hot end. Cura and MakerBot print software are more efficient with this in my opinion.
The Github link is here: https://github.com/slic3r/Slic3r