I gang

RFID module design and Prototype

Create a 3D model of an RFID module holder, detailed drawing to be provided. The device is approximately 3 inches wide, ¾ inch tall and 2 5/16 inches deep. The project bid should include design, sourcing and production of a total of ten prototypes for testing, deliverables are listed below:

1. Review of design and recommendations for production options.

2. 3D design based on drawings provided.

3. Conversion of measurements to metric, if necessary.

4. Source file for 3D printing and recommendations for file format.

5. Prototypes to be produced in black using ABS or some other equivalent flexible, durable material.

6. Time line for completion of project.

Milestones will be agreed to by both parties before project is started.

Færdigheder: 3D Design, 3D Rendering, jQuery / Prototype

Se mere: metric line, prototype review, jquery include, include jquery, drawing printing, create model printing, 505 design, printing rendering, 3d module, model material, device testing, prototype model, printing drawings, RFID, rfid design, review drawings, production drawing, model based design, drawing conversion, jquery file time, create prototype, model format printing, jquery file create, create design prototype, printing model

Om arbejdsgiveren:
( 1 bedømmelse ) Roseville, United States

Projekt-ID: #4075792

Tildelt til:

MEINVEXCELLENT

Hi, Dear. Thanks to share this project to me.

$30 USD på 1 dag
(0 bedømmelser)
0.0

7 freelancere byder i gennemsnit $1247 for dette job

bradleysnider

YOU BUDGET IS $100? I saw the design PDF this is a lot of work for $100?!

$7000 USD in 99 dage
(3 bedømmelser)
4.0
mhom2x

Hi, please check pm. Thanks.

$30 USD på 1 dag
(1 bedømmelse)
1.4
eried

"The project bid should include design, sourcing and production of a total of ten prototypes for testing, deliverables are listed below:" Also shipment? I can design them and print them but probably is faster if you Mere

$400 USD in 60 dage
(0 bedømmelser)
0.0
modeomedia

Hi, You can visit my website at The Administrator removed this message for containing contact details which breaches our Terms of Service I look forward to hearing from you. Warm Regards, Dennis

$100 USD in 3 dage
(0 bedømmelser)
0.0
Xuyao

Dear Sir, I'm profesional mechanical design engineer specializing consumer electronics enclosure design. I'm running 3d design to prototype at daily base. Thanks!

$100 USD in 7 dage
(0 bedømmelser)
0.0
Maodesign

Hello. Please check my portfolio. I'm an expert industrial designer in RFID module project. http://www.grix.it/UserFiles/ad.noctis/BALIA_relazione_mauro_sorrentino.pdf This is a pdf file regarding my graduated thesys w Mere

$100 USD in 7 dage
(0 bedømmelser)
0.0
Bradxenon

I am a Civil Engineer with applicable 3D modeling knowledge and EI certification to assist you with your project. Your budget is set too low for your requirements. Also, it is not clear if you would like the prototypes Mere

$1000 USD in 7 dage
(0 bedømmelser)
0.0