Lukket

Digital Oscilloscope using VB6(Part of Mobile Electronic Workbench)

If anyone of you have used uEWB before?i am sure you have seen the digital [url removed, login to view] job,which becomes yours is to receive signal from dc motor and use A/D covertor with the SAG (signal acquisition-cum-generator module,so mine just work as a viewer,so let's not get too involved with the dll file and SAG [url removed, login to view] right,we have to program an oscillocscope.I have a running program done by my supervisor,now he wants me to write sourcecode to make it similiar [url removed, login to view] can talk things over,my icq is 117376215,contact me... Let's get into business... The mEWB digital oscilloscope offers most basic features of an oscilloscope. Features offered by the oscilloscope are: 1. Display Selection CH1 Display channel 1 signal only CH2 Display channel 2 signal only DUAL Display both channel signals ADD Add channel 1 and channel 2 signals and display as channel 1 SUB Subtract channel 2 signal from channel 1 signal and display as channel 1 X-Y Display XY plot with channel 1 as X-axis and channel 2 as Y-axis 2. Time Base Control Sec/Div 0.1 ms to 5 s (Note: For settings greater than 0.2 s, the oscilloscope operates in a "slow sweep" mode) Delay Up to 20 s (depending on sec/div settings) 3. Trigger Control Source CH1, CH2 Slope Positive Edge, Negative Edge Level 5V to 5V in [url removed, login to view] steps 4. Trigger Status LED indicates successful triggering (GREEN) or unsuccessful trigger (RED) 5. CH1, CH2 Setting Volt/Div 0.1 V to 5 V Vertical Position Over scope height Coupling DC, AC, GND 6. Special Features Pause/Run Toggle button to temporarily suspend or continue signal acquisition Capture Waveform Capture a copy of oscilloscope (and settings) and place in clipboard as bitmap Calibrate Process to correct for component tolerances used in hardware 7. Acquisition Status LED toggles ON and OFF in between acquisition. If LED does not toggle ON/OFF or becomes RED,cycle (i.e. turn OFF and then ON) power to the signal acquisition/generator module. 8. Turning the knobs Turn the knobs as you would normally, Clockwise to increase setting Counter-clockwise to decrease setting Relpy to me after the download,if you still have that confidence inside you,then you are the one i am looking for....

## Deliverables

Complete and fully-functional working program(s) in executable form as well as complete source code of all work done. Complete copyrights to all work purchased.

## Deadline information

[url removed, login to view] not,b4 1st Feb 2002,Wrting comments to make the program readable is [url removed, login to view]'s the quality that matters.

Evner: Ingeniørarbejde, MySQL, PHP, Software Arkitektur, Software Testning, Visuel Kunst, Visual Basic

Se mere: x-axis, vertical sweep, VB6 Job, vb6 0, things to write to get a job, sweep all, power up program, power part 2, oscilloscope dll, mine control, digital code, copy wrting, component part, code electronic, part channel, write mobile, VOlt, power electronic, motor control, mobile e

Om arbejdsgiveren:
( 0 bedømmelser ) Taiwan

Projekt ID: #2833773

2 freelancere byder i gennemsnit $77 på dette job

simplycreativevw

See private message.

$85 USD in 14 dage
(8 bedømmelser)
3.2
acemayo

See private message.

$68 USD in 14 dage
(1 bedømmelse)
0.0