I have a laptop which should be used for a webcam security with motion detection. For this, I would like to use 'Motion'. This is freely available for Linux.
The software has to film what the webcam sees and save a movie to the hard disk as it detect motion. An example can be found on <[url removed, login to view]>
It also needed to use the web interface as shown on <[url removed, login to view]>
In order for you to complete this project I will provide:
- Laptop whit a clean Linux Fedora 2 installed (without GUI)
- Laptop connected to the internet through an ADSL 2240/426 Kbit internet connection (behind a router)
- Root account on the laptop
- SSH access (through port forwarding)
- Access to the http server (through port forwarding)
To make it short, it is a simple installation of the Motion software, as can be found on:
<[url removed, login to view]>
1) Deliverables must be in ready-to-run condition, as follows (depending on the nature of the deliverables):
a) For web sites or other server-side deliverables intended to only ever exist in one place in the Buyer's environment--Deliverables must be installed by the Seller in ready-to-run condition in the Buyer's environment.
2) Documentation of the things that have been done. This can be in a 'quick and dirty' way. However, based on this document it should be possible to install the software after a reinstall of the Linux Operating system
The software has to run on a Pentium 233 Mhz MMX laptop with 160 MB RAM. The webcam is a 'PHILIPS Webcam ToUcam FUN II (PCVC830K)'. According to
<[url removed, login to view]> all Philips webcams are supported by Motion in general and according to <[url removed, login to view]> this specific webcam in supported by Linux