Tildelt

Cisco Routing/BGP

This project is to update the configuration on our router to send some of our traffic out of our network via our second Internet provider based on the source IP (on our network) or port.

Physical Setup: All servers are connected to one of 7 internal switches (3560-48TS-S). Each internal switch is connected to the edge switch (3560G-24TS-E). Edge switch has three bgp Internet connections.

Notes on setup:

- There are 10 primary vlans for each block of IPs that we have

- There are three internet providers

- Most traffic comes in through provider A, we prepend the as-path for providers B & C

- All traffic goes out through provider A

- Provider C is a backup in case provider A and B are down

- We use BGP

- We only receive the default route because of switch limitations

- Software version is 12.2(25)SEB1 C3560-IPSERVICES-M

- We have a cold spare edge router with software 12.2(58)SE1 C3560-IPSERVICESK9-M

Task 1 - Route some traffic out through provider B based on the source IP. Provider A has better performance, but costs a lot more than Provider B. I would like to send some lower priority traffic out through provider B. I have a few servers/IPs that have this lower priority traffic and would like to send their traffic out based on their IP address. It would be nice if this traffic used provider B by default and fails over to provider A (or C) if provider B is down, but the fail-over is not necessary. It is OK if the only route out of our network for these IPs is through provider B. The IPs will be a small subset of our IPs, probably only 6 or six out of a /24. THIS MUST BE COMPLETED TO RECEIVE ANY PAYMENT.

Task 2 - Route some traffic out through provider B based on port. I would like to send all SMTP traffic out through provider B. Again, it is OK if the only route out of our network for smtp is through provider B.

I had a Cisco Certified engineer work on this and he couldn't complete task 1. He had a solution with setting up a route-map with next-hop and adding ip policy route-map to the vlan interface. When this was implemented, traceroute from a server with one of the IPs was still routed through provider A. He suggested that it may be a problem with the switch software (old version). I upgraded our backup switch to the version he provided and duplicated the configuration, moved all cables to the backup switch and it still didn't work. Tried a few variations on the config and no luck.

I will not provide direct access to the switch, maybe a screen share app. I will provide the configuration. I will need all configuration changes that need to be made and any details for troubleshooting/testing. I can provide any diagnostic information you want.

If there is another option for achieving the same goal of sending some of our traffic out through provider B, I'm open to it. We consistently use about 100Mbps of bandwidth and burst up to 200+Mbps. The goal is to keep outbound traffic through provider A somewhere near 100Mbps. There are just a few IPs/Servers that cause the bursting and routing their traffic seems like the most likely solutions.

If you bid on this project, please send PM with a brief description of the solution that you would implement and/or what might be wrong with the current setup. The answer in the PM will indicate that you have read the full description. With out it, your bid will not be considered.

TASK 1 (OR A SOLUTIONS THAT ACHIEVES THE SAME THING), MUST BE COMPLETED TO RECEIVE ANY PAYMENT.

Færdigheder: Cisco, Netværksadministrator

Se mere: setting-out engineer, out source c++ engineer, open source project for software testing, need second engineer, i need a network engineer, cisco connected, all in one network solutions, access interface solutions, what is performance testing, what is network administration, traceroute map, setting up cisco router, cisco certified, certified network engineer, what is software engineer, vlan, router switch, router cisco, network troubleshooting, network performance, Network Engineer, network cisco , network administration, engineer task, cisco engineer

Om arbejdsgiveren:
( 20 bedømmelser ) Roseville, United States

Projekt-ID: #5980732

17 freelancers are bidding on average $400 for this job

asadsethi

Dear Hiring Manager i would like to see the configuration that the previous network engineer did ? and can you please give me the output of the " show sdm prefer " after viewing the above two i could give yo Mere

$444 USD på 1 dag
(88 bedømmelser)
6.3
tiht20

Dear Sir, I'm CCIE certified with more than 10 years experience with Cisco products. I believe I have the talent and skills to satisfy your needs. Agree for not receiving any payment until first task completed. Mere

$500 USD in 10 dage
(41 bedømmelser)
5.4
akmal181

I am CCNP and CCSP with over 15+ years of work experience with 1227+ hours of work and 201 jobs done so far on [url removed, login to view] you deviate Please follow the URL to see my work history on oDesk [url removed, login to view] Mere

$555 USD in 3 dage
(21 bedømmelser)
5.0
PacketScaper

Hello, I am a network and security engineer. The solution is pretty classic solution using route maps , and altering BGP path attributes. However since the Cisco 3560 is used we have to do some further work around t Mere

$400 USD in 2 dage
(22 bedømmelser)
4.8
abasit7

Dear Client, I hope you are fine. I am really happy and excited to see such a challenging task of my field on interest after a long time. I am CCNP in combination with Electrical engineering degree helping me solve Mere

$250 USD in 10 dage
(9 bedømmelser)
4.4
vixun4

I'm a CCNP and CCSP professional having massive knowledge in cisco products (Switches,Router,Firewall ASA5520,Sonicwall).I have built up several IPsec site to multipoint VPN Tunnel/GRE Tunnel over IPsec,and i can compl Mere

$300 USD in 2 dage
(19 bedømmelser)
4.3
mandeepsingh0617

Hi, I have Gone through your scenario and what i have understood is : - You have 6 IP addresses form LAN which you want to Route toward ISP B and in case ISP B goes down traffic of these 6 IP addresses should auto Mere

$400 USD in 4 dage
(15 bedømmelser)
3.9
MikeRRR

Hello, a few words about me: I manage over 300 servers with different purposes: web servers, sql servers, voip servers, filesharing servers, email servers and so on. (most of server are used as voip servers with Mere

$277 USD in 4 dage
(1 bedømmelse)
2.0
inovativesols

Hi, Please contact for further discussion. We will be only able to do this in next two days. Looking forward to work on this. Regards

$777 USD in 10 dage
(1 bedømmelse)
0.8
ranadbbl

A proposal has not yet been provided

$555 USD in 7 dage
(2 bedømmelser)
0.9
sudhir22yadav

i'm pursuing CCNP R&S i have good understanding of BGP and other routing protocols, i can do this job very well.

$333 USD in 10 dage
(0 bedømmelser)
0.0
network2710

CCIE , CCNP and CCNA certified engineer , and 7+ years of experience in networking domain. Working with a major networking company.

$333 USD in 3 dage
(0 bedømmelser)
0.0
thilan3547

Hi, I'm cisco ccna/ccnp/ccip certified engineer working at a leading ISP in Sri Lanka as a network lead position and my cisco id is CSCO11347921. You can check my linkedin profile on romesh samarakone for work ex Mere

$250 USD in 5 dage
(0 bedømmelser)
0.0
rlovakumar

i am CCNP certified [url removed, login to view] in network industry from past 4 years. I am having hands on experience on all routing protocols and i worked on all security related devices.

$337 USD in 10 dage
(0 bedømmelser)
0.0
maheshreddy3812

I have six years experience in setting up routing in bgp. I Worked for one of the leading ISPs in india, where i have configured bgp at client side. LAN integration is one of the important part in setting BGP where Lea Mere

$500 USD in 10 dage
(0 bedømmelser)
0.0
leondobrzinsky

As an ISP support engineer, I have designed and maintained projects with a wide variety of redundancy and load balancing solutions, employing both L2 methods as well as BGP manipulations, route maps, TCL and others. Mere

$333 USD in 10 dage
(0 bedømmelser)
0.0
avinashsingh6188

Working on BGP technology cisco certified for BGP technology and configure with 2 - 3 days and same time we can test using software and arrange proper troubleshooting for outage time

$251 USD in 3 dage
(0 bedømmelser)
0.0