I gang

Arduino drive 7 segment display direct from serial binary data

This project is to decode serial data and display it on 7 segment LED display

Receiving binary serial data @ 9600 on the hardware serial port,

1 arduino per 7 segment display, 8 displays in total, 2 sets of 4, like [8888] [8888]

arduino will have ID specified (binary 4 bit) in the sketch in a variable at the top of the code. (easy to change later)

arduino will have special code set in the sketch in a variable at the top of the code to control digital pin 13. (easy to change later)

once arduino 'sees' it's ID then display the CHAR on 7 segment display (directly driven from arduino using digital pins 5->11

There is a special code to listen for that blanks 7 seg, and set digital pin 13 low. (00001111)

The byte of information is comprised of 8 bits, no parity and 2 stop bit.

00011001 = 0001(id) and data as binary number 1001=9

00011000 = 0001(id) and data as binary number 1000=8

00001111 = Blank 7 Seg and set digital pin 13 low

01000011 = Special code (I must be able to set this code in a variable at the start of the sketch) this turns on digital pin 13

Færdigheder: Arduino, Microcontroller

Se mere: segment direct arduino, arduino serial segment display, display total segment arduino serial, arduino serial binary data, segment serial binary, display segment port serial arduino, bit display arduino, segment display serial data, arduino serial led segment, top segment, set bits in c, set bits, low bits, digital bits, bit bits, bit binary, binary s, binary bit, direct segment arduino, c binary number, serial port, segment, seg, led display, digital display

Om arbejdsgiveren:
( 68 bedømmelser ) Midvale, Australia

Projekt-ID: #4057642

Tildelt til:

manupakaru

I can do this for you.

$70 AUD in 2 dage
(1 bedømmelse)
1.7