I would like to offer a small Supportticket:
A Xenserver 7.0 Poolmember forgot its configuration. there are VMs an the local Storage, so it should be repaired.
yesterday i had to shut down a Xenserver Pool based on Xenserver 7.0 (Patches to XS70E061 applied) for the Electritian had to work on the Infrastrukture.
I used that downtime to change the physical Location of the Poolmaster. I can not see, that anything changed otherwise.
After Booting the Machines, wirth the MAster at first, the only Poolmember didn't show up in Xencenter. So i went to the Server and looked at the Console. it had started, the management console showed up.
The first things i noticed, were the missing Versioninformation on the top left and in the Status Display, The Information "No network configured" in the Status Display and no Intercaces shown up in "Network and Management Interface".
I went to the cli and looked at "xe pif-list" - the Command didn't work - it just gave back a flashing Prompt until ctrl.+c gave a break.
ifconfig -a showed the two physical Network cards and th l0- device. giving an IP to the physical NIC allowed to ping the poolmaster and Gateway.
I tried various articles dealing with lost NICs, but the xe-commands dornt work correctly.
for there are Virtual Disks on the local storage, that doesent show up also in "Disk an Sorage Repositories", i didnt whant to risk loosing Data by reinstalling the System, as al lot of articles describe as a quick solution.
3 freelancere byder i gennemsnit €128 på dette job
Highly interested with your project and I'm ready to start right now. My completion rate is always 100% that I STRICTLY BITE ONLY WHICH I CAN CHEW. Please message me to discuss more!