I have a CentOS 6.5 system that’s primary purpose is to run a software package called Zoneminder ([url removed, login to view]). The software is essentially a security camera monitoring package.
Recently the system was upgraded from CentOS 5.9 to 6.5 which was a new installation of the operating system, new motherboard and hard drives. Following the upgrade of the OS I have not been able to get a video capture card used by some of the cameras to function. The capture card in question is a GrandTex X-Guard.
In CentOS 5.9 I would add a line reading as follows to /etc/[url removed, login to view]
options bttv card=103
The card is seen by the operating system however the method the respective driver seem to be somewhat different.
[root@video ~]# dmesg | grep bttv
bttv: driver version [url removed, login to view] loaded
bttv: using 8 buffers with 2080k (520 pages) each for capture
bttv: Bt8xx card found (0).
bttv 0000:05:00.0: PCI INT A -> GSI 16 (level, low) -> IRQ 16
bttv0: Bt878 (rev 17) at 0000:05:00.0, irq: 16, latency: 32, mmio: 0xf0001000
bttv0: subsystem: 8384:8182 (UNKNOWN)
bttv0: using: Grand X-Guard / Trust 814PCI [card=103,insmod option]
IRQ 16/bttv0: IRQF_DISABLED is not guaranteed on shared IRQs
bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init]
bttv0: tuner absent
bttv0: registered device video0
bttv0: registered device vbi0
bttv0: PLL: 28636363 => 35468950 .
I will provide ssh access to the system for the successful bidder to configure the OS and as well access to zoneminder to help get the cameras connected to the card functional.