Source Code for Arduino Nano to control RC Servo to Simulate Barrier Gate function
$10-30 USD
Færdiggjort
Slået op cirka 7 år siden
$10-30 USD
Betales ved levering
I need help to write a Arduino Software to make a Miniature Barrier Gate.
- Arduino Nano
- 3 tact switch with pull-up resistor.
- One input when pulse to GND open the barrier gate fast ( 1.5 seconds )
- One input when pulse to GND close the barrier gate slowly. ( 3 seconds )
- One input when pulse to GND stop de barrier gate movement.
- When is closing, if pulse the OPEN command, need stop and open immediately.
- When is open, if pulse the CLOSE command, need ignore.
- Use RC Digital Servo Motor. Open is about 85 degrees.
- Open and close movement need acceleration and deceleration to start and stop.
- Open and close must be smooth.
You can watch how the barrier gate move in this video from youtube:
[login to view URL]
Need give the source code to test here in my prototype, if is working well i will release the payment.
Hello dear
I have experience in designing electronics circuits and can make your project. i will make your project practically on breadboard and will provide you circuit, code and PCB design. I can also develop android app for your project. If you wish we can discuss in chat.