I gang

plastic and rubber 3 d shape

I am looking to get a series of climbing holds made for me. They are for childern and need to be able to support 15 stone per hold. They need to be very cheap ideally made of a strong plastic with a rubber skin that does not move.

I have 5 shapes in total.

rock climbing holds are very expensive. I am looking to make some low level kid traversing ones.

So i need some one to help design and price a cheap strong safe alternative.

Færdigheder: Ingeniørarbejde, Fabrikation, Fabrikations Design, Produkt Design, Leverandør Søgning

Se mere: plastic rubber design, shape design, price engineering, level 3 support, engineering price, rubber plastic shape, rubber, plastic design, kid, looking plastic, plastic engineering design, Design plastic, shapes, engineering plastic, rock stone, paulpaulthe3rd, childern, rubber design, design engineering plastic, low level network card, low level programming cnet, low level programming, interface network card low level, desktop sharing low level, preparing low level design document project net

Om arbejdsgiveren:
( 62 bedømmelser ) Dublin, Ireland

Projekt-ID: #989521

14 freelancers are bidding on average $418 for this job

zoAnim

See my PM, Thank you

$250 USD in 5 dage
(54 bedømmelser)
6.5
cadfreak

Hi, I have thoroughly read your requirements and believe that i can deliver exceptional results. i hope you will consider using my services

$250 USD in 5 dage
(24 bedømmelser)
5.5
bchandra1955

Sure a simple and cost effective design with prototype fabrication can be done, Brajesh

$450 USD in 45 dage
(47 bedømmelser)
5.6
caddesignguru

Please see PMB.

$250 USD in 4 dage
(4 bedømmelser)
4.6
TomTong

Ready,pls see PM,thanks

$750 USD in 21 dage
(1 bedømmelse)
4.3
Mzafaraamir

LETS START

$250 USD in 4 dage
(4 bedømmelser)
3.3
sundeep071986

Always ready for work. Please check your private message.

$400 USD in 5 dage
(1 bedømmelse)
2.2
CBRent524

I figure $100 per shape.

$500 USD in 5 dage
(0 bedømmelser)
0.0
adithedevi23

I am currently working on designing cheaper alternatives to existing composite materials with cheaper ones. Please consider me for this project.

$250 USD in 4 dage
(0 bedømmelser)
0.0
sammyjun

Hi , I'm a sourcing specialist in china .Many factories are in there . We can find the items you need .Pls check my pm .Thanks .

$250 USD in 5 dage
(0 bedømmelser)
0.0
DeslgnMobility

KIndly see my PM .Thanks

$750 USD in 15 dage
(0 bedømmelser)
0.0
ariful39

Dear Sir I have a good experience of this Project. So if you want complete this Project cheap rate. Thanks & best regards. Engr. Ariful Islam

$750 USD in 15 dage
(0 bedømmelser)
0.0
akontev

I'm ready to work for you at the smallest price. Best regards

$250 USD in 2 dage
(0 bedømmelser)
0.0
dushyantcc

Hi we are wexperanced in clamping system we are ready to take this opportunity Regards Graphikos Technology Dushyant Chhatbar

$500 USD in 10 dage
(0 bedømmelser)
0.0