I gang

atmel stepper programming for AT90S2313

I need a simple program to run in a stk500, must run OK in avrstudio simulator, for basic stepper control routine, must be clearly commented and this will lead to more coding with slighter increase in payment if complexity increases.

four outputs are to be used for the stepper, a dip switch as input (four lines) is used to control the stepping sequence and two normal off key push button for increase and decrease of the speed the at which the sequence is running.

this is just for the software, no hardware design is necessary, just coding whether in C for microcontrollers (avrlibc) or preferably in assembler for atmel.

Thank you.

please feel free to send any questions through the freelancer platform.

Færdigheder: Elektronik, Indbygget Software, Ingeniørarbejde, Microcontroller

Se mere: at90s2313 programming, at90s2313 simulator, atmel stepper, at90s2313 stepper, at90s2313, atmel stepper control, at90s2313 program software, atmel at90s2313 hardware, software engineering freelancer, programming if, programming basic, key programming software, if programming, hardware design freelancer, freelancer software programming, freelancer software platform, freelancer simulator, freelancer routine, freelancer platform payment, free freelancer platform, engineering program freelancer, engineering lead, design freelancer platform, control freelancer, coding free

Om arbejdsgiveren:
( 1 bedømmelse ) Richmond, United States

Projekt-ID: #958327

Tildelt til:

sid9559

hello, please check your inbox. regards, siddharth

$35 USD in 15 dage
(3 bedømmelser)
2.3