ORCAD board layout

HI I am experienced electronics engineer with more than 13 years of experience in PCB design. I have read the details and would like to know more about it please get in touch to discuss it further Regards

Hello, Hoping you are doing well. I checked your request & I'm ready to help you to finish this project. I'm very familiar with Orcad/ Allegro tool. Please check my profile for more detail. Look forward to corporation with you this time. Kind regards, Dang.

Hi. I am a PCB designer with rich experience over 10 years. If you need, I will show my previous workings for PCB design. Please let me discuss about your project in detail. Best regards, Andrii.

Hi Please share the schematic. I will check it and let you know if I have any clarifications Then I will create the PCB layout and deliver the design files in Orcad tool We can discuss regards Senthil Chennai,India

Hello Sir. I can complete this project perfectly. I have 10 years good experience of hardware development. I have completed a variety of embedded system design and programming by using microcontroller, arm, etc Board PCB design have been completed by using Altium and Protel99SE. Hope to cooperate with you.

hello dear, i am an electrical elecctronics engineer with Orcad expert and can do your task perfectly just text me so i can help you in your task perfectly kind regards

Hello there. I hope to work with you because your project is very familiar for my past works. I have 3+ years experiences in Electrical Engineering & PCB Layout & Circuit Design. Hope further discussion about your project more specific. Regards.

Hello friend, I'm 10 years industry experienced professional in electronics/embedded design and manufacturing industry. So, I'm confident I can deliver you a successful design for your ORCAD PCB requirement. If I mention my professional background little bit, I'm experienced professional (B.sc-applied science/M.Sc-applied electronics) in electronics, embedded micros and PC software programming. In electronics, used Altium, PSpice, Eagle,Easy EDA, KiCAD, Orcad and Proteus design software for circuit simulation and Multi-layer PCB designs, and implementing communications protocols like USB, serial, etc. In Embedded domain, did several projects using Arduino, PIC and AVR ,STM8, STM32, cypress PSOC micros in C/C++. And also exposed to VHDL for Altera and Xilinx FPGAs too. Thanks and Regards, Niroshan R

Hi, I am an Electrical engineer and I have experties in PCB development. I can develop the PCB in OrCad based on your schematic diagram. I will provide Your a Gerber file as well as a 3D view of the PCB. I have done a similar project before and you can see that in my employer feedback section. please send me your schematic to get started. I am looking forward to working with you. Thank You Adeel Ahmed

Hi I am an electrical Engineer And You Can Check My Pcb Design On My Profile i will be very happy to do your work.

Hello, I'm an electric engineer with large experience in projects, research and higher education in engineering courses, including disciplines regarding Electrical/Electronic Circuits and Control Systems. I have built some kits to provide good explanations for my classes using PSpice and Octave. I'd be honored to participate in your project.