I have a fairly easy project for someone who knows what they are doing with electronics...
Here is what I have...
down function) Relay sends out +12v - stays on
up function) Relay turns off 12v trigger.
So those are my triggers... +12v on and then off is off...
When trigger is +12v I need to output +12v on PIN1, and Ground on PIN2 for an adjustable amount of time, .25-2seconds (adjustable).
When trigger is removed, I need to output Neutral on PIN1 and +12v on PIN2 for a separately adjustable amount of time.
Voltages and such may change a little bit depending on the motor I pick up... but the idea and essentially the cost/difficulty should remain the same.
Basically what I am doing is triggering a motor in forward and reverse. Hope this makes sense... doesn't need to be super elegant... if you can do it on a breadboard that's fine if it works.
31 freelancers are bidding on average $107 for this job
SKILLED ENGINEER: I shall design circuit and layout circuit board than deliver to you schematic, bill of material, and gerber. Please provide datasheet for motor or current parameters for PIN1, and PIN2.