Got a project where I need to extend a USB Type C via a circuit board.
Require someone to route the schematic and PCB.
There are only 2 components, the socket and plug. I have been advised that there is no need for any other components to extend the USB Type C.
Using Wurth components 632723300021 and 632712000021.
Will require doing it in CircuitMaker (it is all I have access to, and will be moving mount points later on, though no traces will be moved).
Attached are photos of the PCB with 1.25mm grid.
The PCB is set up with 4 layers. Don't want to go above this layer count. If an extra 1mm is required that is fine.
Would like this done within the next few days ready for prototype manufacture.
8 freelancere byder i gennemsnit £61 på dette job
Hi I am experienced PCB designer I can do it for you. I have completed a number of projects here. Please review my profile to see the feedback from my previous employers Regards
I will layout this PCB in 2 days using circuitmaker as requested with the required components. High speed traces need to be accounted for and it could be possible to do this on 4 layers.