Lukket

SMT32 microcontroller firmware programming

Please read text project.

I use ST microcontroller STM32F103 and STP16CPC26XTR (16 channels led driver controller)

The software can receive information via RS485 (serial port) and CAN BUS. You can receive 5 frames:

Left Text (5 ASCII char) (5 bytes)

Right Text (5 ASCIIchar) (5 bytes)

State of linear bar, state of curved bar and state of arrows and central LEDs (2 Bytes)

Brightness level (1 Byte). General Adjust PWM (10 steps 10%-100%)

State requirement. Returns the model and serial number (2 Bytes).

CAN BUS Frames is similar but on canbus interfase.

Tasks:

Microcontroller programming. Send source code.

Evner: Arduino, C programmering, Elektrisk Ingeniørarbejde, Elektronik, Microcontroller

Se mere: phone firmware programming, cell phone firmware programming, pic microcontroller visual programming, stm32 tutorial, stm32 programming software, stm32 microcontroller datasheet, stm32 microcontroller programming, stm32 programming, stm32 datasheet, st microcontroller, stm32 ide, mobile phone firmware programming, microcontroller firmware development, microcontroller firmware medical devices, firmware programming arm9, microcontroller dsp programming india, firmware programming project, linux firmware programming, firmware programming, freelance firmware programming

Om arbejdsgiveren:
( 23 bedømmelser ) sargodha, Pakistan

Projekt ID: #17396682

7 freelancere byder i gennemsnit $86 på dette job

ched41

Hello, I have read the details of your job, and I am able to deliver it. Please contact me so that we can discuss the details.

$222 AUD på 1 dag
(42 bedømmelser)
6.0
MUhammadt429i

I have long experience with 8-bit , 16-bit and 32-bit micro-controllers. I work with Microchip (PIC) , Atmel (AVR , SAM) , ST (STM) , TI (MSP) and NXP (LPC) micro-controllers. I use KEIL IDE , Atmel Studio , Code Compo Flere

$25 AUD på 1 dag
(19 bedømmelser)
4.9
PistonProvost

I would need the circuit schematic and operation details, and then provide ARM assembler firmware to do what is required (source and binaries). Will probably require 3 or 4 iterations after you load & debug on your pr Flere

$111 AUD in 3 dage
(1 bedømmelse)
0.6
bmandl

Hello, I am electronics engineer with rich experience on microcontrollers and embedded systems. I have depth knowledge in C and C++. I am looking forward to work on this project. Regards, Blaž Mandl

$166 AUD in 14 dage
(1 bedømmelse)
0.6
roopachaitu

Hi, Hope you are doing good. Ping me if you are ok to work with me.

$20 AUD in 2 dage
(0 bedømmelser)
0.5
$30 AUD in 2 dage
(0 bedømmelser)
0.0
Tony731

stm32 L4 ,F1,F4 driver development many years stm32 L4 ,F1,F4 driver development many years stm32 L4 ,F1,F4 driver development many years UART I2C SPI driver development

$25 AUD på 1 dag
(0 bedømmelser)
0.0