1. Water flow meter
5. Solenoid Valve
6. Think speak
1. When water flows , the water flow meter should measure the pressure of water in liters and the information about how many liters of water is consumed should be transmitted to think speak
2. For the first four minutes , the water should flow and the music from SD card should play through speaker
3. After four minutes, for 3 seconds the water should stop and music should stop. The relay will cutoff the solenoid valve for three seconds
4. After 3 seconds the water flow should continue and music should be played again till it reaches five minutes.
5. After five minutes , again for 3 seconds the water flow and music play should stop. The relay will cutoff the solenoid valve for three seconds
6. After three seconds , the water flow and music play should continue till it reaches six minutes
7. After six minutes, the water flow and music should completely off. The relay will cutoff the solenoid valve for three seconds.
8. The data about the water consumption in six minutes should be sent to thinks peak
Already the project is 80% completed. LCD is displaying the timer, relay cutoff the solenoid valve after 4 minutes, 5minutes and 6 minutes for 3 seconds .
I have the code for water flow meter, SD card and think speak
I just need code alignment in my code.
22 freelancere byder i gennemsnit $36 på dette job
If you want just code alignment i can do that in no time, myself being a programmer I know how important code alignment is. So i can do that in about 2-3 hours or less depending upon the lines of code.
You can negotiate for payment, i need project for my experience in freelance Relevant Skills and Experience I am understanding on arduino programming
I have done this project and working properly at my client location and all the components and sensors are well known for me if allot this project for me I can deliver with good quality within the time