Atmega Micro Controller Programming


We have developed an application which is run on computer as well as a hardware system, which requires a program to capture SERIAL DATA from computer and convert it to CAN STANDARD to send on industrial machines, and conversly. If you are able to perform this project, you may be the best choice, then place a bid on this project.


C , C++ programming




Evner: C programmering, Elektronik, Microcontroller, Atmel, C++ Programmering

Se mere: micro controller programs, micro controller base surveillance system, application note water level controlling micro controller 16f84, atmega pid controller source code, micro controller based digital time measurement sensor, micro controller labview, python micro controller, 8051 micro controller linux, ccs micro controller help, embedded micro controller, micro controller design, project electronic embedded programming, micro controller programmers job pakistan, phase electronic meter pic micro controller, design micro controller labview, micro controller project examble, atmega pid controller code, micro controller electronic vb, micro controller programming lahore pakistan, Micro controller programming cctalk

Om arbejdsgiveren:
( 0 bedømmelser ) United States

Projekt ID: #28264171

9 freelancere byder i gennemsnit $240 timen for dette job


HI I am experienced electronics engineer with more than 14 years of experience. I have read the details and have worked with CAN before. Please get in touch to discuss it further REgards

$800 USD in 10 dage
(217 bedømmelser)

Hi I have lots of experience in Atmega controllers like Atmega , xmega 128, 1280, 2560..etc I do also have implemented a gateway like wifi to CAN, serial to CAN. I have used both built-in can peripheral as well stand Flere

$389 USD in 15 dage
(23 bedømmelser)

Hello sir/ma, I'm interested in taking this task up for you. I am an Electrical Engineer with a masters degree and I have high proficiency knowledge in: FPGA firmware in VHDL and Verilog for Altera/Actel/Xilinx FPGAs a Flere

$40 USD in 2 dage
(12 bedømmelser)

I read your project description , "C programming Micro Controller" carefully. I got your point I can do this project for you perfectly. I am more helpful in the success of each other and are careful in establishing a Flere

$200 USD in 6 dage
(14 bedømmelser)
(11 bedømmelser)

Hello, I am electronics and embedded systems engineer and TA as well. I can interface your Atmega with the PC through serial and a usb converter then interface the Atmega to other devices over a can bus. Contact me to Flere

$200 USD in 7 dage
(10 bedømmelser)

Hello I have more than 15 years of experience in the embedded systems design and pcb design and electronics systems design So let's discuss your project in chat

$250 USD in 7 dage
(6 bedømmelser)

Hello, thank you for your job posting. I read your description about--Microcontroller I am a senior electrical engineer. I have plenty of experience in firmware development and micro-controller developments. I can writ Flere

$50 USD in 2 dage
(2 bedømmelser)

- previous experience in such topics; - eager to discuss a lot in this chat stream; - degree stats / maths;

$80 USD på 1 dag
(0 bedømmelser)