I need Arduino software code for LoRa mesh network using RFM95 & ESP32.
Only SW not HW!!
NOT Peer to Peer communication!!! I need mesh network.
Bid only if you have the solution already developed.
Test will be done using some devices at the same time and disconnecting and reconnecting them.
The sender device will receive the OK if the message was properly received from receiver.
Test for GPIO2 remote control integrated.
Configuration parameters indicated as #DEFINE.
Message to be sent will be set later.
LoRa Frequency: 868MHz
5 freelancere byder i gennemsnit €92 timen for dette job
Hello How are you? I have two ESP32, and I have experience of MESH network I can do REMOTE gpio control via mesh network I am only software developer, I can use arduino ide or espressif