I am an expert with 4 years of experience on CREO.
Have extensive experience on complete design and development of part and assembly level components.
My approach is as follows:
1. To first perform basic hand calculations for generating an initial design concept.
2. Use CAE analysis(CREO simulate - linear static, thermal, etc.) to refine the design
3. Make the appropriate design changes for a design with FOS considerations.
4. Further to the above, I can also perform further optimization of the design for weight and cost reduction.
please send me your requirement for further discussion.
Hi I'm Ravi, good at 3D modelling. Expert certified and have 5+ years of professional experience in PTC Creo.
Communication and well understanding clients need is my speciality.
Just give your work and stay relaxed!
You'll get your work on time with 100% quality and in budget.
Dear sir. I have 3 experience in forklift transmission design( japan company). 3D models and 2D drawing like complicate housing, gear, transmission, transaxle housing, cylinder been done ok. Tell me more detail about your project