Bill of Materials (BOM) Re-Engineering Schematic Review Bill of Materials (BOM) Management Analog Engineers klar til at blive ansat

  • Bill of Materials (BOM) Re-Engineering
  • Schematic Review
  • Bill of Materials (BOM) Management
  • Analog
Forslag:
mere

Lande

Specifik placering

Eksamener

Timepris

Vurdering

Online

  • Ansæt dalong243020
    2.4
    1 bedømmelse $30 USD pr. time
    I'm a qualified Software(C++ /Embedded System) and electronics engineer having rich 18 years+ experiences. Have worked with following peripherals & technologies: - Schematic and PCB Layout using Altium designer, Cadence, Eagle, and so on. - Multi Layer, Flexible, High speed PCB design - Exceptional C++/C /C#...
    I'm a qualified Software(C++ /Embedded System) and electronics engineer having rich 18 years+ experiences. Have worked with following peripherals & technologies: - Schematic and PCB Layout using Altium designer, Cadence, Eagle, and so on. - Multi Layer, Flexible, High speed PCB design - Exceptional C++/C /C# programming skills. - FPGA design using Verilog/VHDL (Xilinx ISE/XPS/SDK/Vivado, Altera Quartus, iCECube) - ARM, DSP, MCUs, Arduino experience. - MPU: Pic16F, Pic18F, Pic33F, Atmega8,16,128,32,8051,8951,8052,80251 - Single board computer: Raspbery pi, Beaglebone, NanoPi - Strong with UART, I2C, SPI, BLE,BT, GSM/GPRS/GPS, xBee, ZigBee. - Especially full experience for BLE HM10, HC05, ESP32, DA14580, nRF52832, 52840, BlueNRG, Developed numerous C libraries for using sensors and shields with STM32 ARM and have experience of creating a device from scratch, doing both firmware and PCB development (Autodesk Eagle CAD). Kind regards. mindre
  • Ansæt sagradoamicus
    2.4
    1 bedømmelse $40 USD pr. time
    I am an Electronics and Electrical Design Engineer with the areas of expertise in Embedded System, product prototyping, PCB design and layout and firmware development for systems. I have proficiency in following software tools: 1. Altium Designer 2. Cadence ORCAD 3. KICAD 4. MATLAB 5. Mikro C (for all...
    I am an Electronics and Electrical Design Engineer with the areas of expertise in Embedded System, product prototyping, PCB design and layout and firmware development for systems. I have proficiency in following software tools: 1. Altium Designer 2. Cadence ORCAD 3. KICAD 4. MATLAB 5. Mikro C (for all controllers) 6. Arduino IDE 7. Raspberry pi 8. Eagle CAD 9. KICAD 10.Proteus Design Suite I also have experience in design of IoTs. I have almost 8 years of experience in development of products including the custom electronics. I can take your project from concept to finished product. I am also experienced in working with a number of communication devices like NFC, GPS WifI, Ethernet, Zigbee, GSM and others. mindre

Hej , her er nogle offline freelancere

Hej , her er nogle offline freelancere, der matcher ""